Checking the Dish Network Receiver or LNB
[Back to Technical Support]

 If you don't get a signal, here are the problems in order of popularity:

a.  Dish is not level (no faking will work here)

b.  Cabling is compromised somehow by a splice, signal splitter or bad connector

c.  Aiming at wrong place because of lack of compass (should have purchased an install kit)

d.  A tree or roof overhang is blocking the path (dish receives signal from a higher angle than you think)

e.  Satellite receiver's on-screen menu settings are incorrect (see above hints)

f.  No voltage from the receiver through the cable leading to the dish (may be checked, see below)

g.  LNB is bad (may have been dropped creating shock-loss)

h.  Dish is assembled incorrectly

 *-Checking voltage- A voltmeter is $6-$10 for a low-end unit at Home Depot or Lowes.  Unscrew the cable from the LNB.  Take one lead (black) and hold it against the outside of the cable connector.  Take the other lead (red) and touch it against the center wire of the cable.  Make sure these leads do not touch each other, as it will ground out your circuit.  (Make sure the voltmeter is turned two clicks to the left from the off position.  There should be a reading of 13V or 18V.  If so, the receiver is sending voltage and the unit is probably OK.  If you can't find the voltage, try all of the voltmeter settings before giving up.  Your voltmeter may be set up differently.  If you ever see 13V or 18V, your voltage is OK.

 After checking all of these items, you might need to consider a professional installer.  *Suggestion- Finish the installation of your satellite system.  Tidy up before the installer comes, as he is likely to charge you only for a service call if he thinks that most of the work has been done.  We can refer you to an installer in your area should you need one.  E-mail us at technical@americansatellitedistributors.com to make a request for a local installer.

If at any time, the installer or yourself determines that the receiver or LNBF is faulty, send an e-mail to technical support and tell them you would like a replacement and detail your findings.  (Note: If you find that your receiver is malfunctioning, call 1-888-220-3474 and ask for the Dish Network technical department.  Ask them to help you check your receiver our over the phone and tell them you need an RMA.  This is the required Dish Network return procedure.  Sorry.)  Send the item to us in its original box.  Make sure to track it, either with UPS, FEDEX or US Post Office.  Send another e-mail to technical@americansatellitedistributors.com stating the cost of the shipping.  If our bench test determines that the unit is faulty, you will not be charged for shipping of the replacement.  Should our bench test determine that the unit is functional, your shipping charges will not be eligible for refund.  A charge of $10 will be assessed for all items that are found functional and then returned to the customer 

If you return an item that is not faulty you will possibly be charged a restocking fee if the item is not in perfect condition. 

 Thanks for your patronage.  Happy channel surfing!

DirecTV for Business, MDU DirecTV, Commercial Satellite from American Satellite Distributors